General Repairs  /  Service

Door Repair, Adjustment, and Replacement in Santa Rosa, California

Sticky, sagging or drafty doors, adjusted or replaced so they open, close and latch the way they should.

I repair, adjust and replace interior and entry doors around Santa Rosa and Bennett Valley. Most of the time that means hinges, latches, weatherstripping and a careful fit, not a whole new door. Insured, tidy and respectful of your home.

Door Repair, Adjustment, and Replacement in Santa Rosa

Doors that fit and finish the opening

A door that rubs, won’t latch or lets daylight through is usually a small fix. I figure out why it’s happening first, then do the least work that solves it: tightening or shimming hinges, moving a strike plate, planing an edge, or hanging a new slab when the old one is past saving.

Door Repair, Adjustment, and Replacement, close-up example
Door Repair, Adjustment, and Replacement, example

Houses settle and wood moves with the seasons. A door that closed fine last spring can start dragging at the top corner, bouncing off the strike or drifting open on its own. Often the cause is hinge screws that have stripped out of the jamb. A longer screw that reaches the framing behind it can pull the door back into line without any planing at all.

On entry doors, fit matters for more than convenience. Worn weatherstripping, a door sweep that no longer touches, or a threshold set too low can let in drafts, water and bugs. I check those while I’m there and tell you what I find.

What to send me first

Photos save us both time. Send a picture of the whole door closed, a close-up of the gaps along the top and latch side, the hinges, and the latch and strike plate. For an entry door, add a shot of the bottom edge and threshold from outside.

Tell me what the door does: where it rubs, whether it latches, and whether the problem comes and goes with the weather. If you want a replacement, let me know if you’ve already picked a door and hardware, or if you’d like help choosing a slab that matches the others in the house.

Some door problems aren’t small jobs. A frame that’s badly out of square, rot in the jamb or sill, or a sag caused by framing above the opening can point to something bigger. Cutting new openings and garage doors are outside what I take on. If a job is heading that way, I’ll tell you plainly so you can bring in the right trade.

Doors that close cleanly again.

What I handle

  • Hinge tightening, shimming and adjustment
  • Planing rubbing doors and sealing the cut edge
  • Latch and strike plate realignment
  • Interior slab replacement in an existing frame
  • Entry door weatherstripping, sweeps and threshold adjustment
  • Knob, lever, deadbolt and hinge hardware swaps
  • Minor jamb and stop repairs related to door fit
Next step

Ready to get started?

Send a few photos or a short description of what you need. I’ll reply with clear next steps and an upfront estimate.

Request an Estimate
Common questions

Door Repair, Adjustment, and Replacement FAQ

Why does my door stick only part of the year?

Wood swells when it’s damp and shrinks when it’s dry, so a door can rub in winter and close fine in summer. I look at the gaps before planing anything, since a hinge adjustment is often enough.

Is it better to plane the door or adjust the hinges?

I start with the hinges and strike, because those changes are easy to undo. I plane only when the door itself is too big for the opening, and I seal the cut edge afterward.

Can you replace just the door and keep the frame?

Yes, if the frame is in decent shape. A new slab has to be sized, mortised for hinges and drilled for hardware to fit your opening, and I’ll tell you upfront if the frame needs work first.

My door won’t latch. Do I need a new lockset?

Usually not. Most latching problems come from a strike plate that no longer lines up with the latch, and adjusting or moving the strike fixes it. If the latch itself is worn out, I can swap the hardware.

Can you fix drafts around my front door?

Often, yes. New weatherstripping, a door sweep or a threshold adjustment can close the gaps. I check that the door is hanging square first, because a sagging door won’t seal no matter what you add.

Do you work on garage doors?

No. Garage door springs and openers are a specialty trade, and I’ll point you that way. The regular door between your garage and the house is something I can look at.